Safety & Security

Overhead Door Cable

Pair of 7' Garage Door Cable For Torsion Springs by Canimex

Security


Pair of 7' Garage Door Cable For Torsion Springs
Canimex

8'6" by 1/8" [7 x 7(7 strands-7 wires per strand)]
Pair of 7' Garage Door Cable For Torsion Springs

Answers

How do I replace and adjust cables on a whiteing overhead door? Its on a dryvan box.?



This is a very complicated thing to explain and also a dangerous repair if you haven't been shown. The reason is you have to pre-load the springs inside, with the door closed. If you look where the cables attach, you'll see 1/2 inch holes spaced on the spool shaft, those are for the preload like...

Alpha Overhead Door - Garage Doors in Billings, MT


For all of your Garage Doors in Billings, MT call Alpha Overhead Door at (888) 659-1095. We offer all types of services like Garages, Overhead ...

Overhead Door R 80 CZ


*Warning: I hammed up the intro way too much.* This is a 1/3HP operator from 1969. It's a chain/cable drive, but this drive goes top over ...

return_links(); ?>

Nothing worth stealing at garbage dump?

If you think there's nothing to steal at a garbage dump, you're wrong.

Area landfills have become the target of thieves.

Carman RCMP are investigating break-ins at landfill sites near Morden and in the RM of Grey.

Police reported a break, enter and theft at a seldom- used construction trailer parked near a landfill site near Morden sometime in the last 10 months. Several items including an air conditioner, table, wash sink and approximately 30 feet of electrical cable were taken.

Another break and enter occurred earlier this month at the RM of Grey nuisance ground shop.

The overhead door and east office main door were pried open, but nothing appears to have been stolen.

RCMP also are investigating the following incidents from their report for the week ended June 6:

• Wednesday, June 1: RCMP received several calls of people swimming in the river and jumping off bridges on Highway 201.

RCMP noted this is a dangerous practice not only because of the risk of injury but also because it can be a nuisance and distracting to passing motorists. Anyone caught doing this may face charges under the Highway Traffic Act.

Overhead Door R 80 CZ | Garage Door Seattle

@rdcstyle6612 Okay I need to know the parts your using. The motor unit itself, is it an Overhead Door like the one in my video, or is it newer? (If you know the model number, that would be a big help.) What kind of remote for the car do you have for it? What type of wall button do you have for it? (Does it have lock/light buttons, do the button(s) light up? How old is the motor unit, wall button, and remote? (estimate their ages the best you can) What brand are these parts?

Ok sorry so i should of explained better. so there are 2 things im trying to figure out with this door. 1st thing is that the reciever that comes with the overhead door motor im am trying to make it function so that it will open with the remote control as im pulling in the driveway. 2nd the control that it is on the wall that opens and closes it is a mastercraft from my previous opener. you said it wont work with my overhead door? if i understood you correct. maybe something is missing?...

Read more...

VGA to RCA Component RGB Cable - 1.8M - M/M - Printers Blog

These cones attach to the spindle which passes through the torqued spring via a roll pin. These cones only move when the garage door is opened or closed as they are secured to the spindle so are not spring loaded them selves. There is a gear wheel at each side of the garage door which runs in a track. The cable is attached to these. I had to remove the cable at one side to replace the gear spindle and managed to remove cable and refit without any hard work? However i need to replace the cone how hard of a job is this? Is it just a case of knocking out the old roll pin and fitting the new cone back into the same place? Any help please preferbly before i do the job there is nothing on the net about this? but then again that is always the way. Yes it is as easy as it sounds however i would suggest using some wd 40 or similar as to not score the hole through the spindle such as i did its an easy task as long as you dont score the spindle by punching out the roll pin it works best if you find a punc that will snuggly fit into the hole but is not to tight as to get it stuck

...

Read more...

Overhead Door Cable News

Wellington: Avian star enchants after dark

New Zealand Herald - Oct 15, 4120

The light was already fading as Tony, my guide, led me upstairs into the gloom and face to face with two vicious velociraptors with a nasty-looking pterodactyl flying overhead. Just round the corner, a Haast's eagle was about to grab a giant moa
Autographed A.J. Pierzynski Mask Stolen From Home

Patch.com - Oct 10, 2011

The homeowner reported he returned from an out of town trip and used the overhead garage door to enter the home. He said there were no signs of forced entry and all exterior doors were locked. The majority of the homeowner's belongings were boxed up
Sears Garage Doors The Woodlands Brings Garage Doors to the Internet Age

PR.com (press release) - Oct 06, 2011

Sears Garage Doors The Woodlands TX, provides same day overhead garage door installation and garage door repair service in The Woodlands, Houston, Kingwood and Humble areas of Texas. They are residential and commercial garage door, garage door opener
2012 Volkswagen Golf R price starts at $33900 for two-door model, $36090 for ...

eGMCarTech - Oct 05, 2011

Like the EA888, the EA113 uses direct fuel injection and double overhead camshafts with variable intake timing. Because the Golf R develops more power and torque than the GTI—256 horsepower and 243 lb-ft compared with 200 hp and 207 lb-ft—a number of
From The Tips Box: OS X Accents, Cable Organisation

Lifehacker Australia - Sep 29, 2011

Those plastic over-the-door shoe pocket thingies work nicely for organising cables and small parts if you don't have space for boxes (and make finding the parts easy). I just reorganized my computer software in a gigantic binder this weekend;